Nakamichi DELTA 20 Operation & User’s Manual

11, 9 TIMEOUT seng (18 SEC - ON) LEVEL seng (LOW / HIGH / MEDIUM) SW VER: Show the firmware version of the unit CUST VER: Show the customer / factory version of the unit Press on the remote or rotate the VOLUME knob on the front panel to adjust the meout duraon or…

7, 5 A scanning operaon will be done when the unit is switched ON for the first me. The DAB icon will light up, and the scanning procedure is started: The scanning procedure could take up to a minute to complete. Press on the remote control to show the Radio staon informaon o…

12, Nakamichi DELTA 20 10 Switch ON the radio, press or key on the remote control to select ALARM 1 or ALARM 2, a blinking or icon will be shown on display. Press to start, press on remote or rotate the VOLUME knob on the front panel to adjust the seng, th…

10, 8 ii) FM mode ONLY SCAN SETTING: Select STRONG or ALL for scanning recepon iii) Available in All Mode DATE / TIME SETUP: Set the Date and Time manually or synchronised to the DAB / FM broadcast signal UPDATE: Select the clock to be automacally synchronised to the broadcas…

8, 6 LISTENING TO THE BLUETOOTH DEVICE CONNECT THE LATEST BLUETOOTH DEVICE Select BT as the audio source using the key on the remote control, the display should display “BT”. For first me use, the unit will go to Pairing mode automacally and the Blue LED will flash slowly. Turn…

5, 3 Slide out baery compartment on rear of remote control (remove baery if replacing). Place new CR2025 in baery well as shown (make sure ‘+’ side is facing up). Re-insert baery compartment. 1. 2. 3. INSTALLING / REPLACING THE BATTERY The remote control comes with one CR2025 b…