Electro-Voice FRX+ 181 Manual, Installation Instructions

Manual, Installation Instructions for Electro-Voice FRX+ 181 Speaker System, Subwoofer (1 pages)

Specifications:

185/185937-frx_181.pdf file (15 Oct 2023)
  • Manufacturer: Electro-Voice
  • Category of Device: Speaker System, Subwoofer
  • Document: FRX+ 181, File Type: PDF Installation Instructions
  • Updated: 15-10-2023
  • Count of Pages: 1
Download FRX+ 181 Manual (1 pages)

Read PDF Document Online:

Data: UPD 15th October 2023

Electro-Voice FRX+ 181 Speaker System, Subwoofer PDF Installation Instructions (Updated: Sunday 15th of October 2023 04:18:44 PM)

Rating: 4.9 (rated by 31 users)

Compatible devices: Force i, XI-1122MHA/64F, TL550D, P1200, C12.2, ELX200-18SP-US, EVID-S12.1B, EVID C10.1.

Recommended Documentation:

Text Version of Electro-Voice FRX+ 181 Speaker System, Subwoofer Manual (Summary of Contents)

(Ocr-Read of Document's Main Page, UPD: 15 October 2023)


FRX+ Series
Transformer Installation
Instructions
12000 Portland Avenue South, Burnsville, MN 55337
Phone:952/884-4051, Fax:952/884-0043
www.electrovoice.com
© Telex Communications, Inc. 9/2003
Part Number 38110-228  Rev A
U.S.A. and Canada only. For customer orders, contact Customer Service at:
800/392-3497  Fax: 800/955-6831
Europe, Africa, and Middle East only. For customer orders, contact Customer Service at:
+ 49 9421-706 0   Fax: + 49 9421-706 265
Other International locations. For customer orders, contact Customer Service at:
+ 1 952 884-4051   Fax: + 1 952 736-4212
For warranty repair or service information, contact the Service Repair department at:
800/685-2606
For technical assistance, contact Technical Support at: 866/78AUDIO
Specifications subject to change without notice.
1.) Place the speaker face down (if possible) and remove the back access hatch.
2.) Locate the 4 mounting holes for the transformer at the top of the baffle board
above the woofer.
3.) With the wiring and connector on the transformer pointing to the LEFT, align the
mounting holes in the transformer mounting feet with the holes in the baffle
board.
4.) On each of the 10-24 machine screws provided in the kit, place a lock washer,
then a flat washer.
5.) Apply a drop of thread locking compound to the threads near the end of each
screw.  Insert the screws into the mounting holes and tighten securely, taking
care not to cross-thread the T-nuts.
6.) Feel underneath the left side of the circuit board on the back of the input panel
and locate the two input wires with a flat connector in the middle.  (If connectors
are not present, see Special Instructions below.)
7.) Carefully withdraw the connector and unplug the two halves from each other.
8.) Unplug the short pigtails from the Voltage Selector wiring harness.  These are
only required on early production units which did not have connectors pre-
installed.
9.) Plug the connectors on the end of the Voltage Selector wiring harness into the
mating connectors from the input panel.
10.) Route the wiring harness around to the left of the woofer and, using the four #6
screws, mount the Voltage Selector board to the left of the transformer within
easy reach of the transformer connector.  (4 pilot holes are provided for this
purpose but may be obscured by finish overspray.)
11.) Secure wiring harness to baffle above and below the woofer on the left side
using the cable ties and self-tapping #8 screws.
12.) Plug the transformer connector onto the desired voltage header, taking care to
align all 8 pins.
13.) Apply the “Transformer Equipped” label over the 8 ohm wattage listings on the
Input Panel and mark the corresponding box for the selected voltage.
14.) Replace the back access hatch and tighten all screws securely and evenly.
Special Instructions for Early Units Without Pre-Installed Connectors
1.) Remove Input Panel mounting screws and pull the panel out far enough to gain
access to the solder lugs.
2.) Unplug the short pigtails from the Voltage Selector wiring harness.
3.) Unsolder the BLACK wire from the lug and solder the BLACK wire from the Red/
Black pigtail in its place.  Do the same with the RED wire.
4.) Follow the RED wire you just unsoldered to where it is soldered to the P.C.B.
and unsolder it at the board.  Solder the GREEN wire from the Green/Black
pigtail in its place.  Do the same with the remaining BLACK wire.
5.) Reinstall the Input Panel in the enclosure.
6.) Resume installation of the kit at step 9.





DOC-ab8ce44a:

Recommended:
SK-50D, DPC-D248-R, NDC-2000, 726 TDE

HPA 001BTL, Lifestyle 235, TITANIUM Series, AMP1-16-M, NS-B951, F-500WP
  • 101010SERVICE MANUALSPEAKER SYSTEM■ DIMENSIONSNS-P8900P.O.Box 1, Hamamatsu, Japan 2006 All rights reserved.This manual is copyrighted by YAMAHA and may not be copied orredistributed either in print or electronically without permission.NS-P8900 (=NS-E89 ...

    Model & Doc Type: NS-P8900 4

  • Operating Instructions Model No. / Modèle SB-HEP10RQT5891-YSpeaker SystemBefore connecting, operating or adjusting this product, please readthese instructions completely.Please keep this manual for future reference.Il est recommandé de lire attentivement le présent manuel avantd’u ...

    Model & Doc Type: SB-HEP10 6

  • TITANIUM-SERIES 25 cm / 10” ACTIVE SUBWOOFER ANLEITUNG / OWNER’S MANUAL GZTB 25ACT Ausstattungsmerkmale / Features • Besonders flaches Gehäuse • Massives Kunststoffspritzguss-Gehäuse • Geringe Stromaufnahme • Basspegel-Fernbedienung • Hochpegel-Eingang mit Auto- ...

    Model & Doc Type: TITANIUM Series 5

  • BEDIENUNGSANLEITUNG • INSTRUCTION MANUALMODE D’EMPLOI • ISTRUZIONI PER L’USO • MANUAL DE INSTRUCCIONESINSTRUKCJA OBSŁUGI • VEILIGHEIDSVOORSCHRIFTENSIKKERHEDSOPLYSNINGER • SÄKERHETSFÖRESKRIFTER • TURVALLISUUDESTAAKTIV-LAUTSPRECHERBOXACTIVE SPEAKER SYSTEMENCEINTE ACTIV ...

    Model & Doc Type: Stage Series 24

Additional Information:
# Brand Model Document Type/File Pages File Size Last Checked
1 Sony
MHC-DX30
2 24/10
2 Definitive Technology
Mythos One
13 2.65 Mb 22/01
3 Aiwa
SC-UC78
14 25/11
4 Klipsch
RSB-14
32 12/01
5 Samsung
MX-T70
56 18/03
6 Gateway
SW103
8 3.29 Mb 24/12
7 MB QUART
NKA 116
2 08/12
8 Klipsch
SPEAKERS
12 24/09
9 Integra
MZA-4.7
28 18/03
10 Yamaha
NS-AP7900EBL
8 3.54 Mb 28/11

Popular Right Now:

# Brand Model Document (PDF) Pages Size Check Date
1 GE
JE740
2 0.05 Mb 01.03.2024
2 Mitsubishi
HD4000U
2 05.12.2023
3 Crestron
CCS-UCA-MIC
2 14.10.2023
4 rtd
USB25407
19 29.12.2023
5 Everpure
4H Cartridge EV9610-00
2 0.41 Mb 22.01.2024
6 Microtest
CT-8750
51 01.11.2023
7 LG
GW825-QSG IQ
58 24.03.2024
8 Fluke
365
20 0.55 Mb 14.09.2023
9 Horizon Hobby
F4U Corsair S
21 10.01.2024
10 Binatone
ST-555
28 05.10.2023
Operating Impressions, Questions and Answers: