Matrox Digidesktop Installation Manual And User's Manual

23, Matrox Digidesktop 13 Use the PCI retainer brackets TriMedia Module), simply remove the screws holding the bracket in place and then carefully remove the bracket. In the case of DigiDesktop with the TriMedia Module, however, the PCI retainer bracket also acts as a spacer between the base circuit board and the T…

50, 40 Appendix A, DigiDesktop Cables and Connectors Cable overview The DigiDesktop input/output cable (DTOP/IO/CBL) supports two Y/C (S-Video) or two composite video inputs and one VGA output. Two cables are required per card. DigiDesktop adapters (DTOP/VGA/ADP), each of which provides an HD- 1…

39, 29 Displaying DigiDesktop information Displaying DigiDesktop information To display system usage and other information about your DigiDesktop, click the DigiDesktop tab, then the Information tab. You may be asked to provide this information if you call the Matrox DigiSuite Cus…

20, 10 Chapter 2, Hardware Installation If you already have a graphics card If you already have a graphics card in your system, you must switch to the standard VGA display driver in Windows NT and remove your card before installing DigiDesktop. To switch to VGA mode: 1 Choose Start | Setting…

47, 37 Problems, possible causes, and solutions Possible cause 2 Faulty hardware installation Your DigiDesktop hardware may not be installed properly. Possible cause 3 Driver may not be running The DigiDesktop software drivers may not be running. To verify this, run Control Panel | Ser…

35, 25 Using the DigiSuite Configuration program Default button To restore the factory default settings for your card set, click the Default button. If you have more than one card in your card set, you can choose which settings you want to restore. Save and Load buttons The Save button lets you sav…