Matsutec HP-33A Operator's Manual

68, XTE (Cross-Track Error) alarm The XTE alarm warns you when own boat is off its intended course. How the XTE alarm works Speed alarm The speed alarm alerts you when the boat’s speed is higher than the alarm range set. WAAS alarm This alarm alerts you when the WAAS signal is lost. No…

59, 8. Press the MENU/ZOOM key several times to close the menu. Note: To restore waypoint to a route, select [Skip Off] at step 7, and press the ENT key. 5.3 How to Erase a Route You can erase routes individually or collectively. 5.3.1 How to erase a route through the route list Note: The route used …

60, 6. DESTINATION Destination can be set by four methods : by cursor, by waypoint, by route and by MOB posi-tion. Previous destination is cancelled whenever a new destination is set. The setting by MOB position is described in chapter 1. When setting a destination, a blue line is shown between own…

57, 5.2 How to Edit Routes You can edit the route created. Note: When the route is set as current route navigation, the message "Route is set as a destination. Are you sure?" appears. 5.2.1 How to replace a waypoint in a route 1. Press the MENU/ZOOM key twice to show the main menu. 2. Se…

40, Matsutec HP-33A • CPA : default 6 km • TCPA : default 6 min Push M ENU/ZOOM key to cancel or press E NT key to save the configuration. 2.7.6 AIS External Alarm Buzz Co n t rol Choose to switch on/off the external alarm buzz. 2.7.7 Setting Channel TX Choose to switch on/off the channel TX. If channel TX is swi…

24, 2. AIS Alarm Alarm message will pop up on the screen, such as below. The test alarm is shown in color green. 2. Details of the AIS Targ et The detail screen shows information about the selected AIS target. The contents differ, depending on the AIS target type. In the detail screen…