Ness Security Products Securityguard III Programming Manual

19, Doc ID. SG3PROG00103_03_2014.DOC 19 SUPVIS SUPERVISION STATUS (default = 8) Non-supervised devices: If enabled, a system alarm will occur if the detector has not triggered for 20 ARM/DISARM operations. The count starts after the device’s first…

14, Ness Security Products Securityguard III Doc ID. SG3PROG00103_03_2014.DOC 14 4. To cause a device to send a LEARN message: Device Mode Learn Procedure Unencrypted Press any button 3 times Key Encrypted Hold down PANIC button for approx. 8 seconds Unencrypted Trigger device Sensor Encrypted Disconne…

20, Doc ID. SG3PROG00103_03_2014.DOC 20 V-ARM VOICE ANNUNCIATION ARM/DISARM (default = ON) OFF Armed and disarmed events not annunciated ON Armed and disarmed events annunciated V-ALRM VOICE ANNUNCIATION ALARM (default = ON) OFF Alarm events not annunciated ON Alarm events …

5, Doc ID. SG3PROG00103_03_2014.DOC 5 HOME 2 Press ON button three times (successive presses less than 4 seconds apart) to enter HOME 2 mode. When display extinguishes system is armed in HOME 2 mode. HOME 2 mode may only be entered if programmed and SecurityGuar…

28, Doc ID. SG3PROG00103_03_2014.DOC 28 “Radio fail from sensor two. Check sensor two” Sensor Open chirp chirp, followed by “Sensor two open. Close door or window for sensor two” Dialler Radio Fail chirp chirp, followed by “Radio link to dialler fail. Check dialler” D…