Melco EP 1B Installation, Operation And Maintenance Manual

18, 3-2 EP 1B Operation Manual Melco Embroidery Systems Figure 2-4 7. Pass the thread through the embroidery thread take-up lever from the left to the right; and then pull it downward toward the first lower thread guide. Figure 2-5 Figure 2-6 8. Hook the thread into the two lower thread guid…

23, 3-7 Bobbin Thread Tension For the best possible results, it is important to use the bobbin reels and bobbin thread that was furnished with your machine. Melco recommends the use of prewound bobbin thread, which is available from Accessory Resource Corporation. 1. Put the filled bobbin reel…

34, 5-5 Move Menu Moving The Hoop Numerically Press [MENU] until the display reads MOVE MENU, then press [ENTER]. The display will read X, Y MOVE. Press [ENTER] again and the display will read X+00.00 Y+00.00. Move the cursor to the area you want to change by pressing [ï] or [ð]. Change th…

41, 6-4 EP 1B Operation Manual Melco Embroidery Systems Replacement Parts Light Bulb If the light bulb needs to be replaced, swing open the door to the left of the takeup lever. Disconnect the machine from the power supply. Refer to Figure 6-7 to change the light bulb. Tool Kit The tool kit c…

9, Melco EP 1B 1-3 Dangers de service Attention! Ci-dessous vous trouverez les descriptions de diverses zones de risque ou points dangereux lors du service de la machine. Il faut tou- jours porter des lunettes protectrices pendant le service de la machine afin d'éviter des blessures en cas d'u…