Melco EP 1 Installation, Operation And Maintenance Manual

44, EP 1 QUICK REFERENCE HOOP SELECTION MENU 1. Press [ENTER]. 2. Use [UP] or [DOWN] arrows to select hoop size. 3. Press [ENTER]. MOVE MENU 1. Press [ENTER] 2 times. 2. Use the [LEFT] and [RIGHT] arrows to set number positions. 3. Use the [UP] or [DOWN] arrows to select appropriate numbers for m…

26, 4-2 EP 1 Operation Manual Melco Embroidery Systems Enter Key Used to choose different menu options and to display design information during embroidery. Press once during embroidery and the stitch count and preset maximum embroidery speed are dis- played. Press again during embroide…

20, Melco EP 1 2-6 EP 1 Operation Manual Melco Embroidery Systems 4. Gently jiggle the case like a yo-yo. The tension should be loose enough that a small amount of thread (about an inch) unwinds from the reel, then stops. If no thread comes out, the tension must be decreased. Loosen the setscrew sl…

1, Installation, Operation, and Maintenance manual for the EP 1 embroidery peripheral • Single head, single needle • Easy to operate • Low power consumption • High-quality results Part Number 11034, Revision A …

15, 2-1 2. Needles, Bobbins, and Threads This chapter covers how to thread your machine, select and install needles, wind the bobbin reels, and properly set the upper and lower thread tensions. Threading the EP 1 1. When routing the thread, apply a small amount of pressure on the supply spool to p…