Mellanox Technologies BX4000 Series Quick Start Manual

13, BX 4000 Sereies Quick Start Guide Mellanox Technologies Rev 1 13 Enable NETWORKING support [Y/n]: (Default “Yes”) Enable NETWORKING_IPV6 support [y/N]: (Default “No”) Enter GATEWAY an IP Address: <IP_ADDRESS> Enter a hostname [Ex: localhost.localdomain]:&l…

10, BX 4000 Sereies Quick Start Guide Mellanox Technologies Rev 1 10 Power Cycle the Gateway To run the gateway through a power cycle: 1. Run: halt (if possible) 2. Wait long enough to let the gateway halt, and verify there is no ping to it. 3. Unplug the power cord. 4. Plug i…

14, BX 4000 Sereies Quick Start Guide Mellanox Technologies Rev 1 14 BOOTPROTO=dhcp Do you want to save the selected configuration? [Y/n]: (Default “Yes”) Y - will save the new configuration and redirect you to the main menu N – will redirect you to the main menu Se…

7, Mellanox Technologies BX4000 Series BX 4000 Sereies Quick Start Guide Mellanox Technologies Rev 1 7 Figure 4: Installation Kit Parts Procedure The following procedure can be done by one person, but inserting the gateway is much easier with two peo- ple. 1. Place the ESD mat on the Floor where you will be working and …

1, Mellanox Technologies Inc. 350 Oakmead Parkway, Sunnyvale, CA 94085 Tel: 408-970-3400 Fax: 408-970-3403 www.mellanox.com BX4000 Series Quick Start Guide Document Number 3054 Rev 1.5 Quick Start Guide Overview Mellanox BX4000 series is a 1U, top-of-rack gat…

15, BX 4000 Sereies Quick Start Guide Mellanox Technologies Rev 1 15 FabricIT BX Management FabricIT BXM is a software based management system that can be run with either a com- mand line interface or with a GUI interface. The GUI interface ca n be run through the Web. A license is re…