Meyers Manx Kick-Out Traditional Build Instruction Manual

9, Floor Pan Gasket Placement Needed: Stock VW floor pan gasket or truck cap foam insulation, contact cement, scissors. The floor pan gasket is fitted to the perimeter of the pan where the pan meets the body. In the corners, dart the …

11, TOOL LIST: 1. You will need 4 spring clamps (or “C” clamps) 2. Drill motor 3. 3/16” dia. drill bit 4. 3/8” dia. drill bit 5. Countersink bit 6. Masking tape or packaging tape Step #1 – Two molded in dimples will be found near the lower front edge of t…

10, Once the body mounts have been adjusted with the hammer, the upper angled flange should be parallel to the fiberglass as shown. When satisfied with the fit, have a helper hold the body in place while holes are drilled for the …

6, Pan Shortening - Continued Page 4 of 5 brake lever hole and then remove the short sections of the tubes. Then put a hose clamp around the front of the remaining emergency brake tubes so they will come together just behind the brake handle when the pan halves are…

23, OPTIONAL PARTS INSTRUCTIONS: REAR DECK LID ASSEMBLY INSTRUCTIONS The design of these hinges was to move the deck lid away as it opens, avoiding interference from the roll bar. We have completed the hinge assembly for you. The plastic edge trim provides a finished…