Micro Direct SmokeCheck Operating Manual

15, 13 Note: Please remove the battery if the meter is likely to be unused for some time. Caution: Do not open the battery cover when the device is turned on. Caution: The operator should not touch the contacts of the battery and the patient at the same time. Please Note: D…

18, 16 Safety Designation per IEC 60601-1 Type of protection against electrical shock Internally powered Equipment Degree of protection against electrical shock Type B applied part Power Equipment Battery type: 9 volt battery, Alkaline Manganese Dioxide 9.0V, 550mAh…

7, Micro Direct SmokeCheck 5 Contraindications There are no known contraindications for using the Smoke Check monitor. Warnings and Cautions The following terms are used as follows in this manual Caution: Possibility of injury or serious damage Warning: Conditions or practices that co…

13, 11 The plastic tubing supplied with the gas should be pushed firmly over the reducing connector. Turn the control knob fully counter-clockwise until knob will not turn any further. Apply gas for 25 seconds and then use the calibration button tool to depress the calibration button. …

17, 15 Trouble Shooting Information Should you encounter problems operating your Smoke Check meter, please consult the table below: Problem Possible Cause Solution Smoke Check cannot be switched on or “bat” is displayed Batteries are flat Change the battery …

26, 24 Customer Contact Information For all sales order processing for products, training and spare parts, service and technical support inquiries, please contact the following: Micro Direct, Inc. 803 Webster Street Lewiston, ME 04240 Customer Service and Sales …