Microgate OPTOJUMP Next Operation & User’s Manual

174, Version 1.10 Pag. 174 di 203 Run Data Columns TExt. [s]: External time: available only for external impulse. This is the time between the event (start/stop) of the impulse and the entry/exit into/from the OptoJump bars; it can also comprise split times Time [s]: prog…

73, Microgate OPTOJUMP Next Version 1.10 Page 73 of 203 4.2.3 DEFINE / EDIT PROTOCOLS In this section the protocols to be performed can be defined or edited. The protocols can be considered as a pre-defined series of tests to be performed in sequence (e.g. one ‘Squat jump’ + on…

90, Version 1.10 Page 90 of 203 Should you realize that the assigned starting foot is wrong, just follow the above-stated procedure and switch the selection. Treadmill Running Test and Treadmill Gait Test. In this case the foot touching the ground after the START command is assigne…

122, Version 1.10 Page 122 of 203 During the test session it is possible to ACTIVATE only one registered heart-rate monitor at a time. To do so, select the device and press the <Activate> button. The device will move to the top of the list and is ready for use. …

16, Version 1.10 Page 16 of 203 1.5.2 GYKO FOR JUMP ANALYSIS Using field tests and in particular vertical jump analysis has always been a widely used method for evaluating lower limb muscle strength. OptoGait is the instrument used to measure and objectify the main features of a jum…

100, Version 1.10 Page 100 of 203 4.3.2 COMPARE In this section two selected tests are compared. The display structure is similar to the one presented in the previous section. Due to lack of space it is not possible to simulate the bars with the LEDs, which is possible when viewing …