Microh Titan RGB 6W Operation & User’s Manual

6, 5 For installations where the DMX cable has to run a long distance, or is in an electrically noisy environment, it is recommended to use a DMX terminator. This helps in preventing corruption of the digital control signal by electrical noise. The DMX terminator is simply an XLR pl…

2, 1 TABLE OF CONTENTS 1. INTRODUCTION AND UNPACKING 1 2. SAFTEY INSTRUCTIONS 1-2 3. OPERATION INSTRUCTIONS 2-3 4. MOUNTING AND INSTALLATION 3-4 5. DMX-512 CONTROL CONNECTIONS 4-5 6. MENU NAVIGATION 5-6 7. DMX CHANNELS 6 8. KEY FEATURE…

7, Microh Titan RGB 6W 6 PC Control If the unit is set to ILDA mode (use PC software to control light), simply connect ILDA signal to DB25 jack. ILDA mode(PC control) and built-in program mode can be identified and transmitted automatically. 7. DMX CHANNELS Channel No DMX512 fig. Content Channel 1 …

9, 8 10. MAINTENANCE AND CLEANING The following points have to be considered during the inspection: 1) All screws for installing the device or parts of the device must be tightly connected, and must not be corroded. 2) There must not be any deformations on the housing, colour le…

8, 7 8. KEY FEATURES - RGB Colour Mixing DPSS Diodes (Red650nm, Green 532nm, Blue450nm) - Pre-Programmed Beam Shows and Animations (Total of 128) - On-Board Digital Display - Controllable via DMX (3 Pin XLR) - IDLA Input for PC Control - High Speed Quality 35K Scan Motors (Max 30,000…