Pages Preview:
|
BES-1240 1 With the power to the machine ON. 1) Remove the Phillip’s head or thumbscrew (J) on the side of the cap drive system. 2) Pivot the arm bracket lever (K) up and slide the bracket (H) to the right and remove from the pantograph (M). 3) Loosen the black knob (G) and slide the pivot bar (F ...
BES-1240, 1
MO-80CB 2-Needle,3/4-Thread Overlock Sewing MachineSurjeteuse-Raseuse 2 Aiguilles, 3/4 FilsMaquina de coser Sobreorilladora da 2 Agujas, 3/4 HilosInstruction ManualManuel d instructions'Manual de instruccionesMO-80CBIMPORTANT:Read all safety regulations carefully andunderstand them before using your se ...
MO-80CB, 93
LS-1217 AFilling the bobbinPlace the thread spool on the spool pin and pass thethread around the bobbin winder thread guide.Pass the thread throughthe hole on the bobbinfrom inside, and slide thewinding shaft to the right.While holding the end ofthe thread, depress thefoot controller.When the bobbin is full ...
LS-1217, 2