Related to Tascam 488 MKII Recording Equipment:
-
Plasmatronics
D232
D232 send commands through it to the Dingo. Some com-mands will result in the Dingo sending data back to the computer. The D232 also has a loopback command.Default communication settings:9600 baud, 8 data bits, Even parity, 1 stop bit. (Modbus defaults). All communication is Modbus RTU mode. Modbus ASCII ...
D232, 2
-
National Instruments
PXIe-4163
PXIe-4163 GETTING STARTED GUIDEPXIe-4163PXIe, 24-Channel, ±24 V, 50 mA PXI Source Measure UnitThis document explains how to install, configure, and test the PXIe-4163. The PXIe-4163ships with NI-DCPower driver software, which you can use to program the module.Note Before you begin, install and configure you ...
PXIe-4163, 20
-
Murphy
CANdrive Module CDV100F
CANdrive Module CDV100F BEFORE BEGINNING INSTALLATION OF THIS PRODUCTDisconnect all electrical power to the machineMake sure the machine cannot operate during installationFollow all safety warnings of the machine manufacturerRead and follow all installation instructionsWARNING As part of the MurphyLink® family, CANdrive o ...
CANdrive Module CDV100F, 4
-
Hunter
27157
27157 Hunter ON/OFF Fan & Light ControlModel 27157Ratings: 120 VAC, 60 Hz,1.0 Amp Fan Receiver Weight: 6 oz. 300 Watts incandescent lightRead and Save these InstructionsCaution: Risk of Electrical Shock!All wiring must be performed in accordance with national and local electrical codes. If you ar ...
27157, 2
