Midtronics PowerSensor Micro700 Instruction Manual

5, SIDE VIEW Figure 1. Clamp connection to stud adapter TOP VIEW Testing the Battery Pack 1. Connect the red clamp to the positive (+) lug on the battery at one end of the pack (Figure 3). 2. Connect the black clamp to the negative (–) lug on the battery at the other end of the pack. 3. For a prop…

9, NOTE: if you want to test up to 6 batteries in succession and store each test result and code for printing and viewing, use the In-Vehicle Battery Pack Test. When you start a new test by connecting to a battery after completing the Battery Pack Test, the analyzer will delete the la…

1, Midtronics PowerSensor Micro700 INSTRUCTION MANUAL For testing 6- and 12-volt heavy- duty automotive, commercial, and marine batteries and 12- and 24-volt charging systems. …

12, • 9 • STARTING SYSTEM TEST You can perform the Starting System Test by itself or within a Full System Test IMPORTANT: Make sure the battery or battery pack is in a good state of charge before the Starting System Test. If the result for the Battery Pack Test was CHECK BAT. PACK, or the result fo…

7, • 4 • 2. Select the BATTERY CHEMISTRY: LEAD ACID AGM-SPIRAL AGM-OTHER 3. CHOOSE TEST: OUT-OF-VEHICLE Out-of-Vehicle tests individual batteries that are electrically disconnected from the vehicle. Although you can test more than one battery in succession, the analyzer stores fo…

20, PRINTING PROBLEMS Status LED When a printer fault occurs, the STATUS LED will flash. You can identify the fault by the number of sequential flashes: Solutions • If the IR transmitter and receiver are not aligned, all the data may not print. The infrared ports on the top of the Micr…