MIMAKI UJF-706 Manual 

11, 11 Other precautions Problems or notes Causes and solutions When the vacuum of the absorbing plate is turned off during cutting media, the media slips. The machine has nonslip mechanism, however, this problem can occur from an imbalance in the tension bars which is caused by the widely d…

8, Setting check before printing 8 Checking the printing data Location and size of the printing data In the effective printing area of 700 mm wide x 600 mm long, locate data in the center of the media as much as possible. For thin media, get a non-printing area around the data (20 …

5, About Media 5 You can print on the media shown as the figure, however, you may have to widen the head gap (The image becomes blurred) or the media may cockle during printing. You should not use such a media, which is unfit for UJF-706. Check the media to be used, and use them depen…

7, 7 Setting check before printing 7 ロール保護カバーの確認 8 Check the setting of the UV level. 9 Check the setting of the mist fan. Check that the roll protection cover covering the turning bar at the upper part of the take-up side does not open. For thin media of 50�…

9, 9 Check during printing The feeding condition can change after starting printing, depending on the setting of the media, characteristics of the media, or type of the image data. Check the condition until it stably prints continuously for two to three meters. Check point If problems are not solv…