MIMAKI UJV-160 Operation Manual

46, 2-16 Take-up device Select the take-up direction of media with the switch of the take-up device. Lever, top (REVERSE) : Winds the media with the printed side facing in. Lever, middle (OFF) : Does not wind the media. Lever, bottom (FORWARD) : Winds the media with the printed side facing out.…

12, xii Precautions for use CAUTION Protection against dust Periodic exchange parts • Use this machine in a room that is not dusty. • When leaving the work place after the working hours, be sure to remove the media from the roll hanger to avoid dust. • Store media not to put dust on it. …

106, 4-10 Avoiding ink dripping at printing Ink droplets from the mist at drawing may arise on the bottom of the carriage. As the ink droplets may drip and stain the media or cause blur or dot missing, clean the bottom of the carriage periodically. 1 Turn the power on. • After initial…

149, 6-11 Function Flowchart 6 Appendix :-9999 ~ 9999 : NORMAL/ DIRECT PLEASE WA I T PR I NT I NG [1]MEDIA COMP. ADJUST = 0 Print completed or [1]FEED METHOD SETUP : NORMAL :OFF / PICTURE [1]PRINT MODE LOG I CAL SEEK : OFF :STANDARD/ FINE/ FAST [1]PRINT MODE QUAL I TY : STANDARD :Bi-…

45, MIMAKI UJV-160 2-15 Setting media 2 Basic Operations 11 Prepare the take-up device. • Set an empty core to the take-up device. 12 Press the key to select “ROLL” . • The media width is detected. 13 Fix the media on the take-up device. ( 1 ) Feed the media up to the core of the take-up device with the k…

146, 6-8 <LOCAL . 1> [ #01 ] :English/Japanese FUNCT I ON DISPLAY <ENT> DISPLAY Japanese <en t > FUNCT I ON SET UP <ENT> SETUP FUNCT I ON MACH I NE S E T UP < EN T > MACHINE SETUP FUNCT I ON MA I NTENANCE <ENT> MAINTENANCE or or or …