Pro'sKit MT-2018 Operation & User’s Manual

1, MT-2018 Protective Function Analog Multimeter User’s Manual 1 st Edition , 2011 ©2011 Copyright by Prokit’s Industries Co., Ltd. 1 INTRODUCTION This Multi-meter is an accurate, safe, battery operated, rear tilt-stand, easy to operate handheld instrum…

2, 4 CALIBRATION Ohms Zero Adjustor located at the right side of the panel, adjusting the meter pointer to the Zero mark on the right side of Ohm scale of the meter dial when the test leads are touched together. Mechanical Adjustor Screw: located right below the center of the …

3, 8 3. Short the leads by touching the probes together. Pointer should read zero at the right hand end of the uppermost scale, if it doesn’t, use the Ohm adjust knob on the right hand of the panel to line up the pointer with zero. ( If pointer can’t be brought to zero, r…

4, Pro'sKit MT-2018 12 WARNING: DO NOT APPLY VOLTAGE TO MEASURING TERMINAL WHILE MAKING ANY CAPACITANCE MEASUREMENTS. BEFORE TESTING ANY CAPACITORS, DISCHARGE THE CAPACITOR COMPLETELY. BEFORE MEASUREMENTS, PLEASE READ THE INSTRUCTIONS OF MT-2007-C CAREFULLY. 1. For measuring the Capacitor over 25uF: 1)…

5, 16 規格表： 測試功能 檔位 準確度 說明 直流電壓 DCV 0-0.1-0.5-2.5-10-50-2 50-1000V ±3%FSD(滿刻度) ±4%FSD(1000V 檔) 輸入阻抗：20KΩ/V 超載：Max 1000V 但在 0.1V/0.5/2.5V /10V 各檔，250V Max. 交流電壓 ACV 0-10-50-250V-1000V ±4%FSD(滿刻度…

6, 20 6. dB 測試： 本機測量 dB 值時，要將紅色表棒插入專用“OUTPUT＂插孔，黑 色表棒插入專用“-COM＂插孔; 然後檢視電錶讀數。 測量在 10V 檔上進行，可直接讀取 dB 刻度(-10dB~+22dB)。 測量在 50V 檔上進行時，刻度…