Pro-tec SYSTEM ONE PTS-2 Operation & User’s Manual

7, PROGRAMING KEY FOBS PROGRAMMING THE KEYFOB AND RECEIVER Programming can either be done when the unit is first powered up or in the disarm status only. 1. To program the receiver to key-fob, momentarily short out the two program jumper pins on the circuit board. If done correctly, GREE…

5, Pro-tec SYSTEM ONE PTS-2 Your system has Nuisance Prevention Circuitry (NPC). It prevents annoying repetitive trigger sequences due to faulty door pin switches or environmental conditions such as thunder, jackhammers, airport noise, etc. It is designed to lock out an alarm trigger for two hours if two alarms are generated…

6, KEYPAD OPERATIONS Entry/Exit Delay This is a programmable delay time that must be used to operate the interior keypad. In arming the alarm, the alarm will not be activated or the siren will not sound until after the preset delay from 0 to 35 seconds in 5-second increments has expired.…

1, PRO-TEC SYSTEM ONE Trailer Security Systems Model # PTS-2 Photo includes PTS-2 with optional pager unit “Professional Technology to Pro-Tec Your Investment” …

4, that door. 3. Connect 14 gauge wire from trailer running lights circuit to terminal block. NOTE: The control unit is able to handle up to 15 amp loads. 4. Connect 14 gauge wire from positive side of trailer brake to brake output terminal Note: The 12 Volt automotive battery must be grounded t…