Pfaff 1163 Adjustment Manual

16, Pfaff 1163 Adjustment 13 - 12 13.05.03 Position of the stationary knife Requirement The centre of the stationary knife 1 should be at needle hights and should have a distance of 3.5 mm . Fig. 13 - 11 ● Adjust stationary knife 1 (screws 2) in accordance with the requirement. For technical reasons it m…

19, Adjustment 13 - 15 76-042 13.07 Adjusting the automatic presser foot lift –910/93 Requirement When the automatic presser foot lift is operated, the presser foot should be 9 mm above the needle plate. ● Adjust shaft 1 (screw 2) in accordance with the requirement. Fig. 13 - 14 1 2 76-053 …

15, Adjustment 13 - 11 Fig. 13 - 10 13.05.02 Adjusting the control cam Requirement When the take-up lever is at its t.d.c., the cutting operation should have been concluded (roller lever is pushed out of the control cam). ● Adjust control cam 1 (screws 2) in accordance with the requirement. …

24, Adjustment 13 - 20 A D 1_ 2 _ _ _ 3 _ AB D A B D 13.10 Reset / Cold start After selecting the reset menu, by pressing the corresponding key it is possible to delete seam parameters, delete seam programs and to carry out a cold start. ● Press and hold "+" on keys A and …

26, Adjustment 13 - 22 13.12 Internet update of the machine software The machine software can be updated with PFAFF flash programming. For this purpose the PFP boot program and the appropriate control software for the machine type must be installed on a PC. To transfer the data to the machine, the PC…