SEAL 54Base Operation & User’s Manual

10, 10 User Manual 54Base 2.3 Process principle In all processes the materials are fed through the nip from the front side to be joined together by pressure. A process that makes maximum use of the machine is shown in Figure 3. Shown is a double sided laminating (decalling) process. The…

14, 14 User Manual 54Base 4.2 Installation Note: Make sure that the machine, in its final location, has adequate space. You will need room to feed, receive and trim images. See Figure 6. L = Maximum board length, S = Minimum space 60 cm.(24”). Figure 6: Working space. 1. Move the ma…

20, SEAL 54Base 20 User Manual 54Base 5.3 Placing film rolls This section describes the loading of the machine with laminating or mounting films. The films are loaded onto the shafts at the rear side of the machine. Note: Always work in the center of the machine. Select films that are slightly wider …

28, 28 User Manual 54Base Using release liner • Use a roll of release liner in the lower section. • Web the upper and lower section of the machine as described above (section 5.4.3). When the images are cut from the result, the release liner will separate from the image automatically. 5.5.5…

12, 12 User Manual 54Base 3.3 Material specifications Maximum width: Metric American Process up to 40°C (104 °F) 1400 mm 55.1 in. Maximum roll diameter: Material unwind (upper unwind) 240 mm 9.4 in. Material unwind (bottom unwind) 305 mm 1 ft. Release liner wind…