ACR Electronics RCL-75 Product Support Manual

15, Y1-03-0158H 14 Figure 18 Figure 19 block and screw tightened securely. Gather wires together and install new cable ties (see Figure 19). 21) Replace the top cover carefully, making sure the partition is seated in its proper groove and the screw holes at the fron…

7, Y1-03-0158H 6 bulkhead, use a cable outlet (available at marine hardware stores). Wire should be supported where necessary by the use of cable straps. The location selected must be sufficiently rigid to support the weight of the total installation. Also consider surrounding h…

4, ACR Electronics RCL-75 Y1-03-0158H 3 SECTION 1 - HOW THE SEARCHLIGHT WORKS The RCL-75 was specially designed for mariners who require a high intensity remote controlled searchlight that is compact, light weight and can stand up to the tough marine environment. The RCL-75 searchlight sys…

14, Y1-03-0158H 13 12) Install new bulb, aligning the larger hole toward the back of the tube with the G-clip hole. Do not touch bulb with bare hands (see Figure 16). 13) Re-install G-clip. 14) Install the rubber sleeve over the base of the reflector, flush to the G-cl…

8, Y1-03-0158H 7 CAUTION: The connectors on each side of the wire harness are different. Test fit connector to switch before running the harness to the light. For ease of installation, a 17-foot (5.18 meter) wiring harness to connect the remote control to the light has been supplied. The …

6, Y1-03-0158H 5 Tools and fasteners needed for installation The following tools and marine-grade fasteners are needed for installation but are not included in the light kit. 4 each, 1/4” dia. bolts 4 each, Lock nuts OR 4 each, 1/4” dia. Lag screws 4 each,Washers …