Hasselblad Winder CW Instruction Manual

7, 7 camera is already wound. If the camera was unwound, however, it will now be automatically wound (and an attached loaded lm magazine will be advanced by one frame, see note below). Removing the winder 5 Remove the lens. Firmly grip the winder and depress the winder cat…

5, 5 Hasselblad Winder CW The Winder CW (3044105) is a compact, ergonomically designed unit providing not only a motor drive facility but also a comfort- able and robust grip for the 503CW and 503CXi cameras. It features single exposure, continuous exposure, multi-exposure and remote control …

8, 8 remain at ‘C’, but if several exposures are required, the mode switch must be set at ‘M’ again so that the process can be repeated. rc = re M o t e co n t r o L For use with the Hasselblad IR Remote Control only. In this position the winder’s modes are selected by wa…

10, Hasselblad Winder CW 10 Troubleshooting Temporary incorrect operation might be caused indirectly by a safe- guarding reaction from the SAI or directly as a result of one or more of the following:  e batteries have been inserted incorrectly  e batteries are exhausted  e batteries are nearl…

12, 12 � Keep the mode selector set at ‘L’ when the camera is not in use or is being stored to prevent battery drain or unintentional camera operation. � Remove the batteries if you do not intend to use the winder for several weeks or longer. Technical Specifications Co m p at i b…