Adaptec XHub4 - Hub - USB Quick Start Manual

5, 4 Plugging in Your Devices Follow this picture to connect your USB 1.1 and 2.0 devices to your XHub4. You can use any USB port on the hub. You can buy additional USB cables on the Adaptec Web site, at www.adaptec.com/buy-cables . See About USB 2.0 Performance on page 1 for information abou…

1, R Adaptec XHub4 Quick Start Guide XHub4 Quick Start Guide.fm Page -1 Monday, July 14, 2003 10:31 AM …

7, 6 Troubleshooting If you have problems using your XHub4 or USB devices, work through this list of troubleshooting suggestions: ■ Ensure that all cables are properly and fully connected. ■ Ensure that the XHub4 is connected to a power source, and that the power source is turned o…

3, 2 Plugging in Your XHub4 Follow the picture to connect your XHub4. You don’t have to power off your computer before connecting the hub. Note: To ensure that all your USB devices operate properly, Adaptec recommends that you always connect your XHub4 to a power source. (To power source) Step 1…

2, Adaptec XHub4 - Hub - USB 1 Before You Begin To use your Adaptec XHub4 ® , you need: ■ A PC-compatible notebook or desktop computer with: ■ A 266-MHz or faster processor ■ Windows ® XP or Windows 2000 (see page 3 for Windows Me/Windows 98SE information) ■ An available USB port ■ One high-quality US…

16, R Adaptec, Inc. 691 South Milpitas Boulevard Milpitas, CA 95035 USA ©2003 Adaptec, Inc. All rights reserved. Adaptec and the Adaptec logo are trademarks of Adaptec, Inc. which may be registered in some jurisdictions. Part Number: 513637-06 , Ver. AA LB 07/03 XHub4 Quick Start Guide.fm Page 18 Mo…