AeroGarden 100629 Quick Start Manual

14, 13 ! Bundle cord when furnishing is not in use. Before planting a new garden, be sure to restart the nutrient timer. • Press and hold “Reset” button until the red “Add Nutrient” light blinks 3 or 4 times (approximately 9 seconds). • Release “Reset” button. “Add Nutrien…

11, 10 Basic Reminders About Your AeroGarden AeroGarden Classic Control Panel Features • Water Level Low When light blinks add water up to “Fill to Here.” • Add Nutrients (Feed Garden - Basic Feeding) When “Add Nutrient” and “Water Level Low” lights start blinking (every 2 weeks), …

8, AeroGarden 100629 3 Starting Your Garden A green light on the Smart Garden Control Panel will light up. Grow Bulbs will come on. Look under Lamp Hood to see if both bulbs are lit. If not, check to see if: • Grow Bulbs are properly inserted in Lamp Hood (page 2, step 1C). • Lamp Cord is plugged into Lam…

9, • Your lights will stay on for about 16 hours and will shut off for about 8 hours. • Your lights will come on every day at the time you plugged in your AeroGarden. Your Light Timer C Select Plant Type B 8 1 2 Your Light Timer is Set To Start Growing Your Plants...Starting Now! If You Would Li…

6, 5 Add Water Using a Spouted Container A 2 Planting Your Garden Plant Your Garden B Lift View Door Fill to “Fill To Here” (located inside the Bowl) When additional water is needed, “Water Level Low” light on Control Panel will blink. Add water to raise level up to “Fill To …

3, Wonderful Plants Seed Kit Remember to replace Grow Bulbs every 6 months. Unpack Your AeroGarden A Base (front view) Lamp Arm (back view) Lamp Hood (front view) Grow Bulbs (2) 1 Quick Start Assembly (No tools required) Plug Lamp Cord into Lamp Hood D Push Lamp Co…