Dodge RAM 1500 1998 Owner's Manual

519, INPUT AND OUTPUT CIRCUITS HARD WIRED INPUTS The hard wired inputs to the EMIC include the fol- lowing: • Brake Lamp Switch Output • Driver Cylinder Lock Switch Sense • Driver Door Ajar Switch Sense • Driver Door Lock Switch MUX - with Power Locks • Fused B(+) - Ignition-Off D…

318, DESCRIPTION - COOLING SYSTEM FLOW - 5.9L DIESEL The diesel engine cooling system consists of : • Cross-flow radiator • Belt driven water pump • Cooling fan (attached to the electronic viscous fan drive) • Belt driven Electronic viscous fan drive • Two piece fan shroud • Radiato…

1042, 8W-70 SPLICE INFORMATION Component Page S101 ...............................8W-15-7 S102 ...............................8W-10-34 S103 ...............................8W-70-2 S104 ...............................8W-10-36 S105 ...............................8W-15-3 S106 .........................…

2298, Dodge RAM 1500 1998 ROAD TESTING WIND NOISE (1) Drive the vehicle to verify the general location of the wind noise. (2) Apply 50 mm (2 in.) masking tape in 150 mm (6 in.) lengths along weatherstrips, weld seams or moldings. After each length is applied, drive the vehi- cle. If noise goes away after …

312, Common causes of runout are: • heat warpage • improper machining • incorrect bolt tightening • improper seating on crankshaft flange shoulder • foreign material on crankshaft flange Flywheel machining is not recommended. The fly- wheel clutch surface is machined to a unique…

1608, (4) Remove air resonator box at throttle body. (5) Unsnap cable from dashpanel routing clip. (6) Remove cable housing from dash panel and pull into engine compartment. (7) Hold throttle in wide open position. While held in this position, slide throttle cable pin (Fig. 33) from throt…