US Robotics 56K SERIAL CONTROLLER FAXMODEM Operation & User’s Manual

31, 56K USB Modem User Guide Command Reference - 25 &J<value>—Auxiliary Relay Option This command is supported to ensure backward compatibility with communications software that issues the J0 command. The J1 version of this command is not supported. The auxiliary relay is never closed. Re…

39, US Robotics 56K SERIAL CONTROLLER FAXMODEM 56K USB Modem User Guide Command Reference - 33 \X<value>—XON/XOFF Pass Through Use this command to restrict the XON/XOFF flow control to the local DCE for processing or have the local DCE send the flow control characters to the remote DCE. Result codes: • OK if <value> = 0—1. …

43, 56K USB Modem User Guide Command Reference - 37 +DCS=<v42bis>,<v44>—Select Data Compression Algorithm Use this command to configure the available compression algorithms. The <v42bis> parameter enables or disables the V.42bis, and the <v44> parameter enables or di…

15, 56K USB Modem User Guide Command Reference - 9 Sample Command E<value>—Command Echo Use this command to instruct the modem to echo characters sent to it. When the echo feature is selected, characters sent to the modem are sent back to the host and displayed on the monitor. Res…

11, 56K USB Modem User Guide Installation Instructions - 5 8. The PWR LED on the modem will light. Congratulations. You have successfully completed the installation procedure. Please register your 56K USB Modem at www.usr.com/productreg/ . Windows 2000 You must be logged in as an …

75, 56K USB Modem User Guide Command Reference - 69 +FPA—Selective Polling Address The +FPA:<selective polling address string> is a 20-digit ASCII string in the range from 0x20—0x7E. This string is sent by the DCE at the time specified by the T.30 recommendation, as long as param…