Pro-face PS3710A-T42 Installation Manual

7, 7 *2 The Soft OFF refers to the state that Windows ® has been shut down and the power is provided only for the electric circuit to boot system. This Soft OFF State is different from what is System Standby set by Windows ® . *3 When built in Pro-face's Windows ® XP Embed…

14, 14 • To improve noise immunity, it is recom- mended to attach a ferrite core to the power cord. Attaching the Power Switch cover For the AC type to conform to ANSI/ISA standards, the Power Switch cover needs to be attached to the main unit. To prevent the USB cable from coming off  Attachi…

6, 6 C RI/+5V Changeover SW COM1 RI Changes # 9 pin (RI <---> +5V). D RI/+5V Changeover SW COM2 RI Changes # 9 pin (RI <---> +5V). E Touch Panel's Communication Changeover SW COM4 USB USB Changes the Touch Panel communication method. (Serial <---> USB) (If "Seri…

13, 13 1. Power Supply Cautions • Input and Output signal lines must be sepa- rated from the power control cables for operational circuits. • To improve the noise resistance, be sure to twist the ends of the power cord wires before connecting them to the Power Plug. • The PS-A unit’s pow…

2, 2 Part Names and Functions Name Description A Power LED / RAS Status Lamp (POWER) B IDE Access Lamp Front Rear A B C F E D I Left Side H G J K Top Right Side L M N TR X V W O 1 Bottom ZP S Q UY 2 PS3710A-T42 N XW 1SUY 2 TR VOZPQ PS3710A-T42-24V LED PS-A Status Green (lit) Normal Ope…

15, Pro-face PS3710A-T42 15 • The PS-A unit’s rear face is not approved as an enclosure. When building the PS-A unit into an end-use product, be sure to use an enclosure that satisfies standards as the end-use product’s overall enclosure. • The PS-A unit must be used indoors only. • Install and …