Force SPARC/CPCI-520G Technical Reference Manual

130, Hardware Dependencies FORCE OpenBoot Enhancements Page 116 SPARC/CPCI-52x(G) 7.3 Hardware Dependencies Note: To make use of the features described in this section proceed as follows: • copy the OpenBoot image from the boot PROM which is a read-only device to the boot flash EPROM (see…

92, Ethernet and EBus2 Devices – PCIO Hardware Description Page 78 SPARC/CPCI-52x(G) PCIO EBus2 DMA channels Additionally, 4 DMA channels for floppy, parallel interface, audio in, and audio out are provided by the EBus2 interface. Each of the 4 DMA channels supports 128-byte deep FIFO…

23, Introduction Ordering Information SPARC/CPCI-52x(G) Page 9 2.2 Ordering Information The following table is an excerpt from the SPARC/CPCI-52x(G) order- ing information at the time of print. Contact your local FORCE COM- PUTERS representative for current information. Table 3 Excerpt …

61, Base-520(G) Installation OpenBoot Firmware SPARC/CPCI-52x(G) Page 47 figuration parameter diag-switch? is true for each test, a message is displayed on a terminal connected to the serial I/O interface A. If the system does not work correctly, error messages are displayed which indi- cate the pr…

113, Force SPARC/CPCI-520G Hardware Description PMC Slots with Busmode Support SPARC/CPCI-52x(G) Page 99 Table 58 PMC# x BUSMODE[1] (ro) response encoding PMC# x BUSMODE[1] Description 0 “Card Present”: PMC module present which has the requested capability and uses the requested protocol 1 no PMC module pr…