JAI TM-9730CL Operation & User’s Manual

34, TM/TMC/RM/RMC-9730CL 26 Software Introduction Figure 19. Use Add/Remove to uninstall AccuPiXEL software. 6.1.5 Accessing the AccuPiXEL software Once the software has installed go to the “Start” menu on the main screen to run AccuPiXEL. Click on All Programs>AccuPiXEL Camera…

12, TM/TMC/RM/RMC-9730CL 4 Installation 2.2.2 Connector Pin Configurations 2.2.2 (a) 12-Pin Connector The TM-9730CL has a 12-pin Hirose connector for power input and signal integration. Pin #1 is Ground and pin #2 is +12V DC. The pinout table is shown…

10, TM/TMC/RM/RMC-9730CL 2 Hardware Introduction Note: The Kodak KAI -0373 imager used in the TM-9730CL is packaged using a clear coverglass that does not have anti-reflective (AR) coatings. This is because the imager is not available from the manufacturer, Kodak, with AR coating on the…

3, JAI TM-9730CL Disclaimer iii TM/TMC/RM/RMC-9730CL Disclaimer The material contained in this manual consists of information that is proprietary to JAI Inc., and may only be used by the purchasers of the product. JAI, Inc. makes no warranty for the use of its product and assumes no …

27, Camera Specifications 19 T M /T MC /R M /R MC - 9 7 30C L 5 Camera Specifications Table 5 Specifications Model TM-9730CL Series Image r TM-9730CL TMC-9730CL Monochrome - 2/3" progressive scan interline transf…

15, Installation 7 T M /T MC /R M /R MC - 9 7 30C L 2.2.4 Power Supplies and Power Cable Setup 2.2.4 (a) Power Supplies The TM-9730CL requires 12V DC power that is obtained through the 12-pin connector located on the rear panel of the camera.…