Johnson & Starley HI-SPEC J32P Manual, Installation, Commissioning & Servicing Instructions

10, 6.8 SAFETY CHECKS: 6.8.1 Check for gas soundness within the appliance. 6.8.2 Spillage test: Carry out a full spillage test as follows, and ensure that the flue operates effectively with all doors closed and any extractor fans in operation. NOTE: If an extractor fan is situated in an adjoining …

6, Fig. 2 Worked example of equivalent flue height 5.1.12 Special consideration must be given to external flues with a view to prevention of condensation and weathering problems. 5.1.13 An approved terminal should always be used; a ridge terminal or “GC1” terminal is specifically…

3, Johnson & Starley HI-SPEC J32P VENTILATED Low level grille 288cm 2 (44in 2 ) FROM INSIDE BUILDING High level grille 144cm 2 (22in 2 ) VENTILATED Low level grille 144cm 2 (22in 2 ) FROM OUTSIDE BUILDING High level grille 72cm 2 (11in 2 ) Table 1: Minimum Effective Areas 4. DUCT SYSTEM (See British Design Manual - Gas fired…

9, 6.4 MAIN BURNER PRESSURE TEST: 6.4.1 Referring to Table 4 ensure that the pressure test gauge indicates the correct burner pressure, a low pressure indicates a regulator fault or low cylinder pressure. 6.5 EXTINGUISHING OF BURNERS: 6.5.1 On the Multifunctional Control, rotate the OPERATING CONTR…

12, 6.4 MAIN BURNER PRESSURE TEST: 6.4.1 Referring to Table 4 ensure that the pressure test gauge indicates the correct burner pressure, a low pressure indicates a regulator fault or low cylinder pressure. 6.5 EXTINGUISHING OF BURNERS: 6.5.1 On the Multifunctional Control, rotate the O…

13, 13 8.5 MULTIFUNCTIONAL CONTROL REMOVAL: 8.5.1 Remove the Burner and Controls Assembly as detailed in 8.2 8.5.2 Disconnect the Thermocouple at the Multifunctional Control, avoiding damage to the capillary. 8.5.3 Disconnect the Pilot Feed Pipe from the Multifunctional Control. 8.5.4 Disconnect th…