Mellanox Technologies SwitchX Operation & User’s Manual

20, Basic Operation and InstallationRev 1.3 Mellanox Technologies 20 3.1.1.4 Bad Port LED Figure 10: Bad Port LED The Bad Port indicator is located on the left side of the connector side panel of the unit. The fol- lowing Bad Port conditions are possible. This LED shows symbol errors. Possible caus…

33, SwitchX 36-Port QSFP 40Gb/s Ethernet System Hardware User Manual Rev 1.3 Mellanox Technologies 33 9. Slide the switch into the rails. 10.Tighten the bolts to 9.2 Nm or 81.5 pound inches. 11. Put the switch into place and screw the bolts into the nuts. Tighten the bolts to 9.2 Nm or 81.5 pound inc…

36, Basic Operation and InstallationRev 1.3 Mellanox Technologies 36 Figure 26: PS Unit Pulled Out To extract a PS unit: 1. Remove the power cord from the power supply unit. 2. Grasping the handle with your right hand, push the latch release with your thumb while pull- ing the handle outward.…

10, Mellanox Technologies SwitchX Rev 1.3 Mellanox Technologies 10 Abreviations FDR — Fourteen Data Rate Mellanox Part Numbering Legend This icon indicates a situation that can potentially cause damage to hardware or soft- ware. BEWARE! This icon indicates a situation that can potentially cause personal injury or dam…

12, OverviewRev 1.3 Mellanox Technologies 12 1.1 Features 1.1.1 Full Feature List 1.2 Serial Number and Product Version Information The Serial number and the MAC for the switch are found on the pull out tab below the USB con- nector. The MAC for the Management PC is also on this tab. This MAC is fo…

64, Rev 1.3 Mellanox Technologies 64 Appendix H: Installation - Sicherheitshinweise (German) 1. Installationsanleitungen 2. Übertemperatur 3. Stapeln des Chassis 4. Redundanter Stromversorgungsanschluss - Elektrische Gefahr 5. Bei Gewitter - Elektrische Gefahr 6. Ans…