METREL T10K Operation & User’s Manual

5, Line Tracer 5 • Disconnect all test leads and switch the power off before opening the Battery cover! • Never touch metal tip of test probes or put fingers over protection barrier. See the figure below: Barrier Correct and safety Wrong and Hazardous live • Max tip voltage = 250…

17, METREL T10K Line Tracer 17 3.1. Tracing Cables in Walls, Ceilings, Floor and Ground, and Defected Fuses Tracing of Hidden Wires on Non-energized Systems OFF Receiver R10K switched in capacitive mode Transmitter T10K is automatically in generator mode Fig. 12. Tracing cable or determination of t…

15, Line Tracer 15 LINES: Non-energized DC powered Transmitter T10K is automatically in generator mode Fig. 10. Tracing the conductor using Test tip …

16, Line Tracer 16 3. Typical applications 3.0. Detecting energized state of installation Unknown state of installation MAINS SUPPLY LEDs LOAD and GEN of Transmitter T10K indicate state Fig. 11. Transmitter acts as energized state detector The transmitter T10K automatically …

13, Line Tracer 13 Hints: continued When tracing conductive loops like pipe installation it is often not possible to disconnect them from each other (taps, radiators etc). In such situations it is possible to inject the test signal into the loop by using a current clamp. R…