Lexycom Technologies TIAMIS-800 Operation & User’s Manual

32, TIAMIS-800 wireless radio transceiver User Manual. Ver. 1.3 DOUM0003AA Page 32 of 35 Appendix A. Settings used by the transceiver. All settings used by the transceiver are listed below in the Table A-1. Table A-1. Settings used by the transceiver RS232 data port cont…

16, TIAMIS-800 wireless radio transceiver User Manual. Ver. 1.3 DOUM0003AA Page 16 of 35 • Each Slave in the network must have their NetworkID and their AddressMask matching the corresponding Master’s settings. • Selected Master’s hopping pattern, HopTableLength, and the …

26, TIAMIS-800 wireless radio transceiver User Manual. Ver. 1.3 DOUM0003AA Page 26 of 35 6. Frame Table The FrameTable of the Tiamis-800 includes total of 96 frames. Each of these frames is executed by the transceiver in sequential order starting from ‘Frame0’. Th…

25, Lexycom Technologies TIAMIS-800 TIAMIS-800 wireless radio transceiver User Manual. Ver. 1.3 DOUM0003AA Page 25 of 35 Table 5-2. Description of LEDs functionality during special modes of transceiver’s operation (Continued) Which LEDs are On Link RF Rx RF Tx CTS1 CTS2 What does it mean Program S…

5, TIAMIS-800 wireless radio transceiver User Manual. Ver. 1.3a FCC Notifications This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference and 2) this device must accept any interfe…

12, TIAMIS-800 wireless radio transceiver User Manual. Ver. 1.3 DOUM0003AA Page 12 of 35 • Each Slave in the network must have their NetworkID and their AddressMask matching the corresponding Master’s settings. • Each Slave in the network must repeat the Master’s hopping …