Pixapro ST-III Manual 

2, Foreword Warning Names of Parts Body Transmitter Panel Battery Installing Batteries Low Battery Level Indication Using the Flash Trigger As a Wireless Flash Trigger As a Wireless Flash Trigger with PC Sync Socket 02 03 04 07 08 Setting the Transmitter Power Switch Power Switch of AF …

5, Installing Batteries As shown in the illustration, slide the battery compartment lid of the transmitter and receiver and insert two AA batteries (sold separately)separately. Low Battery Indication When the battery power (2 AA batteries <2.0V) gets low, Status Indicator Lamp blinks qu…

8, Setting the Transmitter group’s setting turns to the maximum (1/1) or the minimum (Min.). If the current group is in the TTL mode, all the other groups which are in the M mode will change their FEC amount simultaneously. The FEC amount is changeable from -3 to 3 in 0.3 stop increme…

10, Pixapro ST-III Setting the Transmitter Selecting the Operation Method Press the <CH/OK> Button for 5 seconds to switch the operation methods (Method 1/Method 2). ST-III T-S Operation Method 1(by default) Function (under normal status) Enter CH settings; (under settings)Confirm and back to nor…

3, - 03 - - 04 - Do not disassemble. Should repairs become necessary, this product must be sent to an authorized maintenance center. Always keep this product dry. Do not use in rain or in damp conditions. Keep out of reach of children. Do not use the fl…