QualGear PRB-717-WHT Installation Manual

1, 13.6kg (30lbs) RATED 2 Year Limited Warranty2 Year Limited Warranty Version: January 2016 Version: January 2016 PRB-717-WHT Roll Adjustment To make Roll adjustment, first ensure that weight of the projector is supported. Then loosen both M6x70mm bolts with the supplied Allen Key (E) and Wren…

2, Ceiling Mount Projector Bracket Wall Marking Template ・ Stud finder (edge-to-edge stud finder is recommended) ・ Marking pen ・ Electric drill・ 5/32" (4mm) bit for wood studs ・ 5/16" (8mm) bit for solid concrete surfaces ・ Socket wrench ・ Hammer ・ Philips …

3, QualGear PRB-717-WHT H Attach ceiling mount with two screws (H) as shown in the figure on the left. Using a socket wrench tighten each screw until the ceiling mount is firmly attached. 3 4 Using a level, mark the centerline of the stud. Using an edge-to-edge stud finder, find the edges of the stud in the ceilin…

4, Using an electric drill and a 5/16" (8mm) drill bit, drill the four mounting holes to a minimum depth of 2.5" (64mm). Attach ceiling mount with four concrete anchors (G) and four screws (H) as shown in the figure on the left. Using a socket wrench tighten each screw until the …

5, Loosen the M6x12mm Screws using the supplied Allen Key (E) until you can slide the extension brackets freely, as shown. To suit the mounting hole configuration of your projector, you may need to replace the attached Extension Brackets with the additional short or long Extension B…

6, Pitch Adjustment Using an assistant to support the weight of the projector, attach the Projector Assembly to the Ceiling Mount as shown above. Tighten the M6x30mm screws on either side with the supplied Allen Key (E). To make Pitch adjustment, first ensure the weight of the projector is …