SCIEX C100HT Operator's Manual

74, 3. Use a small flat-bladed screwdriver to remove the fuse holder located above the area where the cable connector enters into the inlet. 4. Remove the fuse from the fuse-carrier assembly. 5. Replace the fuse in the fuse-carrier assembly and then put the assembly in the system. 6. Plug in the po…

108, SCIEX C100HT Table E-6 Appearance Properties Dialog (continued) DescriptionLabel Set options for the sub-item, when the sub-item is a line.Line Style, Size, Color Set options for the sub-item, when the sub-item is text.Font, Size, Color, Angle, Text Properties Click to apply the changes and close the d…

53, • To store in the packaging, click (Disengage) to disengage the cartridge and then remove it from the C100HT Biologics Analyzer system. Close the purge port with the seal, and then put the cartridge in the original packaging and store in the upright position. Long-Term Storage …

36, Figure 5-1 Buffer Plate DescriptionItem Location of buffer tray1 Notch for the buffer tray2 Location for the alignment marker3 4. Pull the foil cover off of the buffer tray and then put it in the buffer plate with the buffer tray tab aligned with the notch in the buffer plate. 5. (Optional…

57, Figure 6-3 Qualification Profile All wells associated with the profile update in the Plate pane. Figure 6-4 Wells Associated with Profile View the Data Trace for a Well The Data Trace tab shows the electropherogram and allows the data to be inspected. 1. Do any of the following to …

67, The glycan structures are based on Harvey D.J., Merry A.H., Royle L., Campbell M.P., Dwek R.A., Rudd P.M., Proposal for a standard system for drawing structural diagrams of N- and O-linked carbohydrates and related compounds., Proteomics. 2009;9(15):3796-801. View the Plate Report The Plate Report …