SOMMER synoris 800 Installation And Operating Manual

20, SOMMER synoris 800 42 en Operation Resetting all values All learned values can be reset (e.g. learned in force values for closing and opening the door).  Press the Reset button on the controller housing (1) until the lighting LED “Status“ goes out. While pressing, the LED “Status“ blinks.  Releas…

26, 48 en Maintenance and care  Disconnect the opener from the power (switch off the cir- cuit breaker to the opener or disconnect the fuse on the circuit supplying the opener with voltage) and check to be sure no voltage is present.  Remove coarse dirt from the C-rail.  The chain must be …

29, 51en Troubleshooting Drive stops while the door is opening. Drive opens the door and then gives no reaction to com- mands from the remote con- trol or the wall station (acces- sory). Drive closes the door and then gives no reaction to commands from the remote control or the wall stati…

13, 35en Deleting all learned radio codes  Press the learn button (1) and hold it until – the LED (Radio) initially blinks for five seconds, – and then slowly blinks for ten seconds, – and subsequently blinks quickly for ten seconds. When the LED (Radio) turns off, all radio co…

28, 50 en Troubleshooting Drive does not open or close the door after pressing a but- ton on the remote control. Lighting on the drive does not function. Drive stops while the door is closing and opens the door again completely. 9. Wall station (accessory) not mounted and connected. 10. Broken wir…