CrimeStopper CS-882.OEM Install Manual

1, CS-882 OEM ALARM UPGRADE FOR FACTORY REMOTE KEYLESS ENTRY SYSTEM INSTALLATION PRECAUTIONS & WARNINGS NOTE: This system does not improve or affect the range of the factory remote keyless entry transmitters. This is an ADD-ON system only. The arm/disarm range of this…

2, CrimeStopper CS-882.OEM 2 31 4 ON NEGATIVE VALIDATION INPUTS (TOP EDGE OF 882 MODULE) 2 31 4 ON POSITIVE VALIDATION INPUTS (TOP EDGE OF 882 MODULE) OPERATION PASSIVE ARMING MODE (Programmable Option) When programmed for Passive (Automatic Last Door Arming) the CS-882 will arm itself 30 Seco…

3, 4 ON CURRENT SENSING DIP SWITCH #4 OFF PROGRAMMABLE OPTIONS 1. Turn the Ignition ON and press the Override/Program button 7 times within 10 seconds. 2. Turn OFF Ignition. LED will flash slowly once per second as and indicator the system is in programming mode. 3. Within 20 seconds, pre…

4, WIRING VIOLET WIRE: ON-BOARD RELAY (10A) IMMOBILIZER CIRCUIT #1 NORMALLY OPEN VIOLET WIRE: ON-BOARD RELAY (10A) IMMOBILIZER CIRCUIT #1 NORMALLY OPEN These wires the are for an on board Relay to immobilize the Ignition or Fuel Pump Circuit in the vehicle. Cut the selected circui…

5, WIRING RED/WHITE: (+/-) Door Unlock Validation Signal INPUT: [Default Setting is Negative] Connect to Vehicle’s Door Unlock Switch wire. NOTE: The module must be programmed for the correct signal polarity. Prevents system from being disarmed simply by pressing the vehicle’s …