CrimeStopper SP-200 Installation Instructions Manual

11, 11 OPTION PROGRAMMING NOTE: Options can be instantly restored to Factory Default Values. To restore default values: Perform step #1 (See page 10), then press button 3 (trunk). The siren and horn will chirp 4 times and lights will flash 4 times. Turn OFF Ignitio…

6, 6 WIRING: 4-PIN Shock Sensor (26 Gauge wires) Sensor Adjustment Adjust the main shock sensor with the small White dial. Clockwise will increase sensitivity and counter-clockwise will decrease sensitivity. Adjust Pre-Warning level with small Black dial. GREEN LED RED LED (-) PRE…

3, 3 CAUTIONS & WARNINGS DAMAGE RESULTING FROM IMPROPER INSTALLATION IS NOT COVERED UNDER WARRANTY!! DO NOT remote start your vehicle in a closed garage. Make sure that the garage door is open or there is adequate ventilation. Failure to observe this rule could result …

15, 15 WIRING DIAGRAM Purple Blue Brown/white Red Black Yellow Green Brown Gray Ground 12 Volt Battery Hood Switch Door Switch (-) 86 85 87 30 87A (-) Ignition Sense (+) (-) (-) Horn Honk Factory Car Horn (+) Parking Lights Trunk Pop Relay Remote Output # 1 (+) Siren 86 8…

10, CrimeStopper SP-200 10 OPTION PROGRAMMING 1. Turn the Ignition ON and press the Override/Program button 5 times. 2. After a short delay, the parking lights will flash 5 times, Siren 5 times, Horn 5 times and status LED will be on solid. 3. Within the next few seconds, press the Override/Program bu…

7, 7 WIRING: 2-PIN LED / 2-PIN Program-Valet Button (26 gauge wires) Mount Status LED in a visible location on the Dash or Console. Connect the small 2-pin plug from the LED to the control module. Note: Connectors are designed so that they will only plug into their appropriate slot…