Davis Instruments Rain Collector II Installation Manual

11, Extending Cable Runs 11 To calibrate your station for rounded millimeters, set the console to display rainfall in millimeters and then change CAL to 0005. (See “Rainfall Calibration Number” on page 2 and/or your station user’s manual for instructions on how to change CAL.) Be aware that …

16, Product Number: 7852 Part Number: 07395.224 Rain Collector II Rev B Manual (10/21/05) This product complies with the essential protection requirements of the EC EMC Directive 89/336/EC. Copyright © 2004 Davis Instruments Corp. All rights reserved. 3465 Diablo Avenue, Hay…

10, Extending Cable Runs 10 To Clear Rainfall Daily and total rainfall are independent of each other. You must clear each register separately. 1. Press RAIN once or twice to select daily or total rainfall, as desired. 2. Press CLEAR and hold it down. The display will flash several ti…

1, Rain Collector II Installation manual This instruction manual takes you step-by-step through the procedures required to install the Rain Collector II. The Rain Collector II is designed for use with any of Davis’ weather stations (with the exception of the Perception II ® Station). Each stat…

8, Extending Cable Runs 8 As you reattach the cone, make sure to run the cable to the cable slot in the base, or the cone will not fit snugly against the base. 10.Place the debris screen, points down, into the cone. The screen prevents large bits of debris from blocking the funnel hole. 11.To preve…

9, Davis Instruments Rain Collector II Extending Cable Runs 9 Maintaining the Rain Collector II For greatest accuracy, you should thoroughly clean the Rain Collector II at least once or twice a year. 1. Disconnect the rain collector cable from the junction box. 2. Separate the cone from the base. 3. Use warm soapy water and a soft c…