Vertex Standard FT-200 Operating Manual

81, FT-2000 Operating Manual Vertex Standard Co., Ltd. 81 receiver frequency to center the incoming station on the pitch corresponding to that of your transmitted signal. Using the SPOT System While pressing the front panel’s [SPOT] button, the Spot tone will be heard. This tone …

82, FT-2000 Operating Manual Vertex Standard Co., Ltd. 82 14.000.70 MHz; the latter frequency is what the FT-2000 displays, by default. However, you can change the display to be identical to that of what you would see on SSB by using Menu item “060 A1A FRQDISP” and setting it to “dIr” in…

11, FT-2000 Operating Manual Vertex Standard Co., Ltd. 11  The Attenuator effects to both the Main (VFO-A) and Sub (VFO-B) bands.  The Attenuator may be used in conjunction with the [IPO] switch to provide two stages of signal reduction when an extremely strong signal is being receive…

58, Vertex Standard FT-200 FT-2000 Operating Manual Vertex Standard Co., Ltd. 58 *: When the optional YF-122C (500 Hz) or YF-122CN (300 Hz) CW narrow filter is installed. In the FM mode, both the transmit and receive bandwidths are changed by the [NAR] button. Digital Notch Filter (DNF) Operation The Digita…

56, FT-2000 Operating Manual Vertex Standard Co., Ltd. 56 which will appear as a white area in the colored background area. The tuning rate for the IF Notch is somewhat slow, allowing precise adjustment, so the use of the Waterfall display to confirm proper adjustment is highl…

3, FT-2000 Operating Manual Vertex Standard Co., Ltd. 3  Replace the top cover and its nine screws.  Always uses the 10 A fuse in the fuse holder on the rear panel whether operate on 100 - 120 VAC or 200 - 240 VAC.  Change the voltage marking on the label on the rear panel …