Wintal DVR4CH User Instruction Manual

11, 10 Chapter II System Installation Section 1 Operating Environment The following operating environment for this DVR must be adhered to: DVR Operating Environment Items Instructions Electromagnetism DVR’ complies with National Electromagnetism Radiation Standards. Temp…

5, 4 (Tightening torque: Approx. 0.49 N . m {5 Kgf . cm})  Avoid rapid changes of the temperature/humidity to prevent condensation. (Acceptable change: within 15℃/h{59℉/h}) Before You Start. 1. Do not attempt to open or remove the covers. This may expose you to dangerous volt…

14, 13 considered as an alarm input; ALARM IN port disconnect with GND or has a high voltage (5V) input will be considered as no alarm input by default; Fig. 3 Note: external input voltage can not be higher than 5V. Alarm out Alarm output is NO/NC output, and this DVR has 1 port for ala…

22, 21 Cancel buzzer alarm Admin Current login user CH01 Current channel N otation Icon description / Record status and remote preview switch automatically. ---the current channel is recording manually --- prerecord ---timing recording ---alarm recording ---motion detection …

12, Wintal DVR4CH 11 2. Remove HDD mounting bracket. 3. Fit HDD onto bracket using supplied mounting screws. 4. Replace HDD mounting bracket. 5. Connect the ATX power cable to the power connection on the HDD. Pay attention to the correct orientation. 6. Plug HDD cable into SATA port on HDD. 7. P…