Specifications:298/298609-273355_273355.pdf file (18 Jan 2024)
|
Radio Shack 273-355 273-355 Network Card PDF Installation Manual (Updated: Thursday 18th of January 2024 07:11:58 PM)
Rating: 4.4 (rated by 45 users)
Compatible devices: Enercell 273-318, Enercell 273-354, Enercell 273-328, Enercell 273-356, 624VDC, Enercell 273-332, Enercell 273-331, Enercell 273-333.
Recommended Documentation:
T M M T 9VDC • 800mA AC-to-DC Power Adapter 273-355 Cautions: • If this adapter is not compatible with the voltage and current requirements of your portable device, it can result in PERMANENT DAMAGE to the device. • Before using, consult the User’s Guide or the rating label on your device to make sure it requires 9 volts DC. • The power adapter’s current (800mA) must be equal to or more than the current needed by your portable device. • Before charging cell phones, make sure the cell phone specifications are supported by this power adapter. • Never operate the adapter if it has been damaged in any way. Do not disassemble it. wWARNING: To prevent fire or shock hazard, do not expose the adapter to rain or other moisture. w CAUTION: The total combined current for accessories plugged into this adapter must not exceed 800mA. FCC Information This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equip- ment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Modifying or tampering with your 9VDC 800mA AC-to-DC Power Adapter’s internal components can cause a malfunction, which might invalidate its warranty and void your FCC authorization to operate it. Limited Warranty Ignition L.P. warrants this product against defects in materials and workmanship under normal use by the original purchaser for ninety (90) days after the date of purchase. IGNITION L.P. MAKES NO OTHER EXPRESS WARRANTIES. This warranty does not cover: (a) damage or failure caused by or attributable to abuse, misuse, failure to follow instructions, improper installation or mainte- nance, alteration, accident, Acts of God (such as floods or lightning), or excess voltage or current; (b) improper or incorrectly performed repairs by persons who are not a Ignition L.P. Authorized Service Facility; (c) consumables such as fuses or batteries; (d) ordinary wear and tear or cosmetic damage; (e) transportation, shipping or insurance costs; (f) costs of product removal, installation, set-up service, adjustment or reinstallation; and (g) claims by persons other than the original purchaser. Should a problem occur that is covered by this warranty, take the product and the sales receipt as proof of purchase date to the place of purchase. Ignition L.P. will, at its option, unless otherwise provided by law: (a) repair the product without charge for parts and labor; (b) replace the product with the same or a comparable product; or (c) refund the purchase price. All replaced parts and prod- ucts, and products on which a refund is made, become the property of Ignition L.P. New or reconditioned parts and products may be used in the performance of warranty service. Repaired or replaced parts and products are warranted for the remainder of the original warranty period. You will be charged for repair or replacement of the product made after the expiration of the warranty period. IGNITION L.P. EXPRESSLY DISCLAIMS ALL WARRANTIES AND CONDITIONS NOT STATED IN THIS LIMITED WARRANTY. ANY IMPLIED WARRANTIES THAT MAY BE IMPOSED BY LAW, INCLUDING THE IMPLIED WARRANTY OF MERCHANTABILITY AND, IF APPLICABLE, THE IMPLIED WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE, SHALL EXPIRE ON THE EXPIRATION OF THE STATED WARRANTY PERIOD. EXCEPT AS DESCRIBED ABOVE, IGNITION L.P. SHALL HAVE NO LIABILITY OR RESPONSIBILITY TO THE PURCHASER OF THE PRODUCT OR ANY OTHER PERSON OR ENTITY WITH RESPECT TO ANY LIABILITY, LOSS OR DAMAGE CAUSED DIRECTLY OR INDIRECTLY BY USE OR PERFORMANCE OF THE PRODUCT OR ARISING OUT OF ANY BREACH OF THIS WARRANTY, INCLUDING, BUT NOT LIMITED TO, ANY DAMAGES RESULTING FROM INCONVENIENCE AND ANY LOSS OF TIME, DATA, PROPERTY, REVENUE, OR PROFIT AND ANY INDIRECT, SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, EVEN IF IGNITION L.P. HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. Some States do not allow limitations on how long an implied warranty lasts or the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights, and you may also have other rights which vary from State to State. You may contact Ignition L.P. at: Ignition L.P., 3102 Maple Ave Suite 450, Dallas, TX 75201 02/09 For product support, call 1-866-315-0426. UsingYour Adapter 1. Plug the correct size Adaptaplug onto the jack at the end of the adapter’s cord. • If your device’s DC input jack is marked , align TIP on the adapter’s jack with + on the Adaptaplug (shown). • If the DC input jack is marked , align TIP on the adapter’s jack with – on the Adaptaplug. wCAUTION: Be sure to set the correct tip polarity. Incorrect polarity can damage your device or the adapter. 2. Plug the Adaptaplug into your device’s DC input jack. 3. Plug the AC adapter into an easily accessible power outlet located near the equipment. Protect the environment. Go to E-CyclingCentral.com to find an electronic recycling center near you. Printed in China 05A09 273-355 © 2009. Ignition L.P. All rights reserved. Enercell is a trademark used by Ignition L.P.
Tutorial (s5015, #B5K8WI)
s5015, 49, verykool/s5015.pdf
Roland Handbook: RP401R (#YV9D9F)
RP401R, 26, roland/rp401r.pdf
320.37596 Power Tool - #X7W7DT
320.37596, 28, craftsman/32037596.pdf
Monitor Handbook #5O77QH
iView Stand UID0099, 12, i-display/iview-stand-uid0099.pdf
Thermostat DT Handbook, #E7Z7VH
DT, 33, heatmiser/dt.pdf
5140G Pet Care Product - #583CBL
5140G, 6, havahart/5140g.pdf
Mixer Guidance #T2L95S
246-025, 1, exido/246-025.pdf
Scale Instruction #EC9VCN
Super II, 41, setra-systems/super-ii.pdf
#9GGZTT: IPH-9201-5 Guide
IPH-9201-5, 13, dension/iph-9201-5.pdf
User Guide (Day / Night Speed Dome Camera EPTZ 100, #41Q455)
Day / Night Speed Dome Camera EPTZ 100, 48, everfocus/day-night-speed-dome-camera-eptz-100.pdf
G. For Windows 2000, you maybe informed that a digitalsignature has not been found.This is normal, and it hasbeen verified that theAdapter does work withWindows 2000. Click theYes button to continue.H. After the files have beensuccessfully copied, youwill see Figure H. Click theExit button.Pro ...
Model & Doc Type: WPC51AB 2
Skip to contentManuals+User Manuals Simplified.Home » Actiontec » Actiontec ECB2500c MoCA Network Adapter Installation GuideActiontec ECB2500c MoCA Network AdapterInstallation GuideContents [ hide1 MoCA Network Adapter2 Installation Guide3 Related Manuals:MoCA Network AdapterInstalla ...
Model & Doc Type: ECB2500c 3
Artisan Technology Group is your source for quality new and certied-used/pre-owned equipment• FAST SHIPPING AND DELIVERY• TENS OF THOUSANDS OF IN-STOCK ITEMS• EQUIPMENT DEMOS• HUNDREDS OF MANUFACTURERS SUPPORTED• LEASING/MONTHLY RENTALS• ITAR CERTIFIED SECURE ASSET ...
Model & Doc Type: Quad M-module Carrier i4000 20
TM 18540-A2-GN10-00October 1997HotWire 8540 Digital Subscriber Line (DSL) CardInstallation InstructionsDocument Number 8540-A2-GN10-00October 1997What is a 8540 DSL Card?A Digital Subscriber Line (DSL) 8540 card is a circuit card assembly (CCA) thatcontains four Rate Adaptive Digit ...
Model & Doc Type: 8540 12
# | Brand | Model | Document Type/File | Pages | File Size | Last Checked |
---|---|---|---|---|---|---|
1 | Patton electronics | ipRocketLink IAD 3086 |
12 | 0.47 Mb | 22/11 | |
2 | Quantum | SuperLoader 3A |
4 | 2.09 Mb | 26/03 | |
3 | Crestron | UPX-2 |
8 | 0.37 Mb | 06/11 | |
4 | Hypercom | ATMConnect C5100 |
2 | 28/01 | ||
5 | Linksys | WUSB54GP |
25 | 22/11 | ||
6 | Nortel | 5100 |
160 | 06/02 | ||
7 | HP | 9000 Series 300 |
157 | 18/04 | ||
8 | Sprint | PC3200 |
101 | 1.92 Mb | 29/01 | |
9 | Delta Electronics | Suppression Inductors LFZ24V |
1 | 0.13 Mb | 23/02 | |
10 | D-Link | DGE-500SX |
14 | 0.08 Mb | 25/01 |
# | Brand | Model | Document (PDF) | Pages | Size | Check Date |
---|---|---|---|---|---|---|
1 | KitchenAid | KXI2536YSS0 |
28 | 12.04.2024 | ||
2 | Teledyne | Quantum Series |
369 | 17.12.2023 | ||
3 | Shenzhen | Codejet 128K |
43 | 13.03.2024 | ||
4 | BENDIX | QR-L INLINE QUICK RELEASE VALVE |
4 | 0.18 Mb | 13.10.2023 | |
5 | Philips | 19PR15C |
2 | 0.1 Mb | 26.10.2023 | |
6 | Canon | PowerShot A 720 IS |
37 | 1.43 Mb | 20.01.2024 | |
7 | Copland | DRC205 |
36 | 13.04.2024 | ||
8 | Community | C SERIES CP6 |
8 | 01.02.2024 | ||
9 | Vizio | M3D550SL |
64 | 8.62 Mb | 08.03.2024 | |
10 | DeWalt | DCF889 |
14 | 08.03.2024 |