Snapper 1800 GT Series Operator's Manual

20, Mower Deck Removal & Installation 44” Simplicity, Massey Ferguson or AGCO Models 18 Operating the Tractor Removing the Mower Deck Note: Units with electric height of cut, unplug tractor wire harness from deck harness before removing deck. 1. Park tractor on a hard, level sur…

18, Attachment Operation in Reverse If an operator chooses to operate a PTO driven attach- ment in reverse, the RMO system can be used. To use the Reverse Mowing Option (RMO) turn the RMO key after the PTO is engaged. The L.E.D. light will illumi- nate, and the operator can then operate the attachm…

48, 46 Parts & Accessories Replacement Parts Replacement parts are available from your authorized dealer. Always use genuine Simplicity Service Parts. Technical Manuals Additional copies of this manual are available, as well as fully illustrated parts lists. These manuals show all of the …

35, 33 Regular Maintenance Figure 31. Transmission Oil Reservoir - K66 A. K66 Reservoir Access Hole A Transmission Identification Several service procedures within this book are identified by, and vary by, transmission type. To determine what transmission is in your tractor, check the identi…

12, Snapper 1800 GT Series 10 Features & Controls Throttle Control The throttle controls engine speed. Move the throttle for- ward to increase engine speed and back to decrease engine speed. Always operate at FULL throttle. Choke Close the choke for cold starting. Open the choke once the engine starts. A warm …

30, 28 Regular Maintenance Check / Clean Oil Cooler (Select Models) SERVICE INTERVAL: EVERY 25 HOURS, OR AS NECESSARY The engine oil cooler is located on the side of the engine (A, Figure 19) and should be cleaned with compressed air at regular intervals or if dirty. Safety Interlock System Check SERVIC…