Elenco Electronics FG-600K Assembly And Instruction Manual

11, In each of the following steps, start with the switch and pots as shown on the previous page. 2) OUTPUT WAVEFORMS Connect an oscilloscope probe to the square wave output. You should see about 8V peak to peak square wave of a little over 15Hz. Connect the oscilloscope probe to the s…

1, FUNCTION GENERATOR KIT MODEL FG-600K Assembly and Instruction Manual Elenco Electronics, Inc. Copyright © 1999 Elenco Electronics, Inc. Revised 2001 REV-A 753033 …

7, Elenco Electronics FG-600K -6- ASSEMBLE COMPONENTS TO THE PC BOARD Figure E Mount the pots down flush with the PC board. For R2, install nut. Figure D Electrolytic capacitors have polarity. Be sure to mount them with the negative (--) lead (marked on side) in the correct hole. Bend the electrolytic capacitors as show…

8, Install the colored binding posts to the panel as shown in Figure I. Use the hardware shown in the figure. -7- Nut Lockwasher Binding Post Green Black Backside of Panel Small Nut Green Figure I Figure J Black Binding Post Green Binding Posts Wire from J3 Wire from J2 Wire from J1 WIRING Attach the …

10, -9- Attach the battery snap to the battery. Insert the PC board assembly with the panel and battery into the case (as shown in Figure L). Insert two 4-40 x 1/4” screws into the bottom case in positions shown in Figure M and tighten in place. Turn the shafts on the two potentiometers and rotary swi…

9, Install the handle as shown in Figure L. Cut two pieces of weather stripping. Remove the protective backing and place a piece of weather strip on the top panel in the location shown in Figure L. Then, place the other piece on the case in the location shown. FINAL ASSEMBLY Place t…