Envision EN7410 Operation & User’s Manual

6, v OTHER NOTES • The screen surface is very soft. Do not rub, touch or tap the screen surface with sharp object such as pen or pencil. This contact may scratch or damage the screen. These damages are not covered under the warranty. • Turn your computer OFF before installing your n…

25, 17 Input Signal Line Frequency 31 - 83kHz multi-frequency Image Frequency (Refresh Rate) 56 - 75Hz Within the parameters detailed in chapter 7 Video Signal RGB analogue (Positive polarity) 0.7 Vpp/75 Ohm Synchronization TTL separate, composite TTL Signal Connect…

18, 10 (from left to right) Menu Enter OSD menu. Enter submenus or select items within OSD menu. c Move the selection cursor upwards within the OSD menu. d Move the selection cursor downwards within the OSD menu. e Adjust OSD functions. (Decrease) f Adjust OSD function…

5, iv GENERAL NOTES The following symptoms are normal with LCD monitor and do not indicate a problem. • Due to the nature of the fluorescent light, the screen may flicker during initial use. Turn off the Power Switch and then turn it on again to make sure the flicker di…

7, vi Disclaimer Envision Peripherals Inc. makes no representations or warranties, either expressed or implied, with respect to the contents hereof and specifically disclaims any warranties, merchantability or fitness for any particular purpose. Further, Envision Peripherals Inc. re…

17, Envision EN7410 9 7 7 Adjusting the Monitor Picture Optimisation The easiest way to obtain an optimal picture is by using the Auto button for 2 seconds. This only works reliably if the graphics adaptor is set to use one of the monitor’s factory modes (see Table 1 in the previous chapter) a…