Janome DC 3018 Manual, Instruction Book

35, Janome DC 3018 33 Replacing the Light Bulb WARNING: Turn the power off before replacing the light bulb. The bulb could be HOT, wait until it has cooled down before touching it. To remove: Remove the cap and setscrew. Unhook the hook from the rear cover and remove the faceplate. q Cap w Setscrew…

16, 14 Securing a seam For fastening the beginning of a seam, press the reverse button and sew several reverse stitches. Release the reverse button to sew forward. w Reverse button For fastening the ends of a seam, press the reverse button at the end of the seam. Sew a few stitches in r…

22, 20 1 1 Buttonholes Variety of buttonholes #16 Square buttonhole This square buttonhole is widely used on medium to heavy weight fabrics. The buttonhole size is automatically determined by placing a button in the rear of the foot. #17 Round-end buttonhole This buttonhole is used on fine to medium wei…

17, 15 Altering the needle drop position The needle drop position of the following stitches can be altered: Press the mode key to activate stitch width adjustment (the middle green light lights up). The preset value "3.5" will be indicated. Press the plus (+) key to move the …

30, 28 4 Close the zipper and spread the fabric open flat with the right side up. Baste the upper fabric and zipper tape together. !0 Basting 5Reattach zipper foot E with the left pin. Sew 1 cm (3/8") across the end of the opening with reverse stitches. Stitch through the fabric and zipper tape. !1…

9, 7 Changing the Presser Foot CAUTION: Turn OFF the power switch before changing the foot. Always use the proper foot for the selected pattern. The wrong foot can cause the needle to break. To snap off: Raise the needle and presser foot. Press the red button on the back of the foot holder and…