La Crosse Technology WS-811561 Manual 

12, Page 12 of 12 surface; (4) damage resulting from failure to follow instructions contained in your owner’s manual; (5) damage resulting from the performance of repairs or alterations by someone other than an authorized La Crosse Technology, Ltd authorized service center; (6) units…

4, Page 4 of 12 automatically. When the battery voltage charges to 2.5V, the LCD will turn on and the transmission of signal will start again. 2. Install Batteries into Wireless Display Insert 2 new "AA", 1.5 volt ALKALINE batteries into the wireless display according…

2, Page 2 of 12 Setting the Time Alarm ............................................... 6 Battery Replacement Information ............................... 7 Installation Notes ........................................................ 8 Mounting the Units .....................................…

6, Page 6 of 12 4. Set Time - Hour: Press the “SET” button a fourth time and the Hours digits will flash. Use the “PLUS“ button to select the correct hour. 5. Set Time - Minute: Press the “SET” button a fifth time and the Minutes digits will flash. Use the “PLUS…

5, La Crosse Technology WS-811561 Page 5 of 12 attempted at the full hour between 12:00 am to 6:00 am. For best reception, place the display with the front or back facing Colorado. After a successful reception, no more reception attempt would be made until the following day. If the display is in an area of your home whe…

10, Page 10 of 12 Online Resources Visit the WS-811561 page online at: http://www.lacrossetechnology.com/811561 Care and Maintenance Extreme temperatures, vibration and shock should be avoided as these may cause damage to the unit and give inaccurate readings. Precautions shall be taken…