Lab.gruppen LAB 1600 Operation & User’s Manual

3, Introduction Thank you for purchasing a LAB.GRUPPEN power amplifier. This manual contains important information on operating your amplifier correctly and safely. Please take some time and read this manual to familiarize yourself with the amplifier. The front panel Figure 1. Front pan…

5, There is no ground lift switch or terminal on this amplifier. The signal ground is always floating via a resistor to chassis and the grounding system is automatic. If a potential above 0.6V presents itself between signal ground and chassis ground, a short circuit is introduced betwe…

1, USER MANUAL HEADLINES Unpacking 2 Warnings 2 User responsibility 2 1. Speaker damage 2. Speaker output hazard. 3. Radio interference. Introduction 3 1. Front panel 2. Rear panel Installation 4 1. Mounting 2. Cooling 3. Operating voltage…

7, 8. Impedance matching (MLS-switch) The MLS switch is located on the rear panel with a LED indicator showing then the switch is depressed and in the 2 ohms position. The MLS ( Minimum load select ) switch offer a impedance matching, so you can drive the LAB 1600 in 2 ohms without…

2, Unpacking Carefully open the shipping carton and check for any noticeable damage. Every LAB.GRUPPEN amplifier is tested and inspected before leaving the factory and should arrive in perfect condition. If found to be damaged, notify the shipping company immediately. Only the consignee may…

4, Lab.gruppen LAB 1600 Please refer to diagram on page 3 1. Speaker connector This type of speaker connector may be unfamiliar to some users. A full description is found in the operation section. (See page 6). 2. Clip limiter switch. Turns the clip limiter on and off. 3. Input jack Alternative to u…